TM RACING 125 EN 2022, Руководство по эксплуатации и обслуживанию

Страница: 78 / 130

4•78
22
33
44
55
11
11
4 • MAINTENANCE
2-STROKE - EN
REPLACING REAR BRAKE PADS
FOR MODELS WITH FLOATING CALIPER (EN/MX/SMR/SMK)
- Open the brake pump reservoir by unscrewing the screws (1).
- Push the brake caliper (2) towards the disc, so that the piston returns
to its standard position. Remove the cap (3) with a screwdriver and
unscrew the pin (4) then remove the brake pads.
- Clean the pistons, then push them towards the outside of the caliper
to make room for the new pads.
- Be careful of the fins (5) between the pads: they must be re-fitted with
the greatest of care. Thoroughly clean the brake caliper with compressed
air and check that the surface of the guide pins is intact.
- Fit the new pads, paying attention to the position of the fins. Insert the
pin and tighten it. Re-fit the cap using a screwdriver. Tighten it securely.
WARNING
- Do not operate the brake pedal while removing the pads.
- Check that the pump reservoir oil level is correct. If necessary, top up
as indicated in the relevant paragraph.
DANGER
- AFTER ASSEMBLY, CHECK THAT THE SAFETY DEVICES ARE
CORRECTLY POSITIONED.
- AFTER ANY WORK ON THE BRAKING SYSTEM, OPERATE THE REAR
BRAKE PEDAL TO MAKE THE PADS ADHERE TO THE DISC AND
CHECK THE BRAKE FLUID LEVEL AND THE PLAY.
- ALWAYS KEEP THE BRAKE DISC COMPLETELY FREE OF OIL
AND GREASE, OTHERWISE THE BRAKING EFFECT WOULD BE
SIGNIFICANTLY REDUCED.