TM RACING 125 EN 2022, Руководство по эксплуатации и обслуживанию

Страница: 45 / 130

3•45
11
33
55
6-9 6-9
99
22
3 • INSTRUCTIONS FOR USE
EN - 2-STROKE
WARNING
After a few seconds from the engine start, move the knob (5) or (6) back
to the initial position. If the engine has a low and irregular idle speed (9),
adjust idle speed as described in the relative paragraph “Engine speed idle
speed adjustment”.
The engine idle speed will always have to be kept between 1700-1800 rpm.
This value also eases the next starts.
DANGER
- ALWAYS WEAR SOLID MOTORCYCLE BOOTS WHEN KICK STARTING
THE ENGINE IN ORDER TO AVOID POSSIBLE INJURIES. YOU COULD
SLIP FROM THE PEDAL OR THE ENGINE MAY CAUSE A KICKBACK AND
CAUSE THE PEDAL TO HIT YOUR FOOT.
- ALWAYS PRESS THE START PEDAL STRONGLY UP TO THE END OF ITS
STROKE WITHOUT ACCELERATING. A KICK START WITH A TOO LOW
POWER OR WITH THE GAS KNOB OPEN INCREASES THE RISK OF A
KICKBACK OF THE ENGINE.
- DO NOT START THE ENGINE IN A CLOSED ROOM AND NEVER LEAVE
IT ON IN SUCH ROOMS. EXHAUST GASSES ARE POISONOUS AND THE
MAY CAUSE UNCONSCIOUSNESS AND DEATH.
IN CASE OF ENGINE OPERATION, ALWAYS MAKE SURE SUFFICIENT
VENTILATION IS PRESENT.
- ALWAYS CHECK THAT GEARBOX IS IN NEUTRAL BEFORE STARTING THE
MOTORCYCLE. IF A GEAR IS ENGAGED WHEN STARTING THE MOTOR-
CYCLE, THE LATTER WILL JUMP FORWARD AND MAY CAUSE DAMAGES
TO YOURSELF AND TO THE MOTORCYCLE ITSELF.
COLD START OF THE MOTORCYCLE
Cold start is intended when the coolant temperature is below 35°C.
- After having made the preparations for start-up as described in the
“Starting the motorcycle” section, operate as follows before starting
the motorcycle:
- Depending on the models, raise the knob (1) or pull the knob (2) and
leave it in position.
- Start the motorcycle as described in the relative paragraphs .
- Run the engine accelerating softly, after approx. 1 minute after the engine
started, move the knob (1) or (2) back to initial position. If the engine
has a low and irregular idle speed (3), , adjust idle speed as described
in the relative paragraph “Engine idle speed adjustment ”.
The engine idle speed will always have to be kept between 1700-1800 rpm.
This value also eases the next starts.
WARNING
Do not make the engine rpm increase too much while it’s still cold. This
may cause damages to the engine. Always let the engine warm up while
stationary or while running at low rpm.