TM RACING 125 EN 2022, Руководство по эксплуатации и обслуживанию

Страница: 49 / 130

3•49
3 • INSTRUCTIONS FOR USE
EN - 2-STROKE
WASHING
- Regularly clean the motorcycle to keep the surface of plastic parts in good condition.
- Use hot water, a cleaning product available on the market and a sponge. Heavy dirt can be removed with a gentle jet of water.
- Plug the exhaust pipe before cleaning to prevent water from going in.
- Remove the air filter as described in the “Maintenance” section.
WARNING
Do not aim water jets directly at the filter case (1), or water may enter the engine zone.
- Use cleaning products available on the market to wash the engine. Use a suitable brush to clean particularly dirty parts.
- Once you have thoroughly rinsed the motorcycle with a gentle jet of water, dry with compressed air and a cloth.
Immediately go for a short ride until the engine reaches the operating temperature and, at this point, also use the brakes. The water left
in the areas that cannot be reached and on the brakes will evaporate thanks to the heat.
- Once the motorcycle has cooled down, oil or grease all sliding parts and bearings. Apply a specific spray to the chain.
- Apply a specific spray for contacts to all the electrical controls on the handlebar and electrical system connectors to prevent faults in the
electrical system.
WARNING
Never clean the motorcycle with a high pressure cleaner or with a strong water jet! Otherwise, due to the high pressure, water could reach
the electrical parts, connectors, flexible cable controls, bearings, etc. and cause faults or lead to early breakage of these parts.
PRECAUTIONS FOR WINTER USE
If the motorcycle is used in winter, you must consider the salt on the roads and take appropriate measures against the corrosive salt.
- Thoroughly wash the motorcycle after every use and let it dry.
- Apply an anti-corrosion product to the engine, exhaust system, frame, swing arm and all other shiny, galvanized or satin finished metal
components (except brake discs).
DANGER
DO NOT ALLOW THE ANTI-CORROSION PRODUCT TO COME INTO CONTACT WITH THE BRAKE DISCS. THIS WOULD REDUCE THE BRAKING
EFFECT CONSIDERABLY.
WARNING
After traveling on roads where salt has been spread, thoroughly wash the motorcycle with cold water and let it dry completely.