![background image](http://html1.mh-extra.com/html/titan/helix-0138011/helix-0138011_operating-manual_1119425021.webp)
21
Setup
HELIX
5.3
coNNecT The SurefIre™ heATeD hoSeS
coNNecT The heATeD hoSeS
Attention
The heated hose assembly and dual whip hose
come pre-installed with the system and should
not be removed or disassembled unless it is
being completely replaced.
i
Refer to the Helix Surefire™ Dual Heated Hose
Manual included with your system.
1. Attach the JIC fittings (packaged separately with the
heated hose set) to their appropriate whip hoses.
a. Connect the smaller JIC fitting to the “A” side whip hose.
b. Connect the larger JIC fitting to the “B” side whip hose.
A
B
2. Remove the coupling block from the spray gun (refer to
the spray gun manual).
3. Close gun manifold valves A and B.
Attention
Always close the manifold valves if the system is
idle for more than 1 minute under heat and/or
pressure. Failure to do so can cause a pressure
imbalance which can then lead to a material
“crossover” inside the gun, leaving the gun
inoperable.
4. Attach the dual heated whip hose to the coupling block.
a. Secure the “A” hose to the “A” side of the coupling block.
b. Secure the “B” hose to the “B” side (or “R” side) of the
coupling block.
B (Resin)
A (ISO)
5. Tighten both hose connections with a wrench.
coNNecT The Supply hoSeS
1. Make sure the valve handles on the inlet valves for both
Component pumps are in the OFF position (see fig. 11).
2. Attach one end of the feed hose to the inlet valve of
Component pump A. Repeat for Component pump B with
another hose.
3. Connect the other end of each hose to their appropriate
transfer pumps (i.e. the “A” hose should run from
Component pump A to the transfer pump installed into
material supply drum “A”).
4. Make sure all connections are wrench tight.
5. Arrange the return hoses:
a. For non-circulation configurations (see figure 2, section
3.1), place a waste bucket underneath each of the return
hoses.
b. For circulation confirgurations (see figure 3, section 3.3)
Attach the return hoses tubes to the dessicant dryers of
the appropriate material supply drum (i.e. the “A” return
tube for should run from Component pump A to the
dessicant dryer installed into material supply drum “A”.
Содержание HELIX 0138011
Страница 12: ...12 SYSTEM DESCRIPTION HELIX A E D F L1 J H K K J N M M B H L2 G I C 3 3 System Diagram with circulation ...
Страница 44: ...44 HELIX Spare parts diagram drive assembly 4 5 6 1 2 3 7 8 9 10 11 18 17 12 13 14 15 16 ...
Страница 50: ...50 HELIX Spare parts diagram fluid section 1 2 3 4 7 8 15 16 17 18 19 20 21 22 23 9 10 11 12 13 14 5 6 ...