Timewave DSP-232, Руководство по эксплуатации

Страница: 29 / 271

Chapter 3 Radio Installation
Note : If you don’t have a spare receiver to monitor the tone, a “quick-’n’-dirty” way to set the
AFSK level is to turn the AFSK LEVEL pot on the back of the DSP halfway between its stops,
but if you happen to have a deviation meter such as AEA’s DM-1 Deviation Meter, set the AFSK
LEVEL’s pot so the DSP’s deviation is 3.25 KHz, peak .)
2. Verify that your DSP and FM radio(s) are connected as shown in Figure 3-4 and/or 3-5 or 3-6 below.
Figure 3-4 Radio-to-DSP Radio Port 1Connections
Note: Radio Port 2 can be wired the same as Radio Port one (shown above) or it can be wired specifically
for 9600 bps packet operation as in either of the two diagrams shown below. This is the beauty of having
both a 5 Pin and 8 pin DIN, you can fit the 5 pin plug into both ports if you don’t run 9600 bps packet,
and for those you do run 9600 bps you can use Port 2 specifically for this purpose.
Figure 3-5 Radio-to-DSP Radio Port 2 Connection for 9600 bps packet
September, 05 3-5