Rev A Nov 2017
Page 26
Chapter 4
Standalone Operation
To use an external analog source for control:
1) Connect the temperature sensor and the TEC element to the "TEC OUTPUT"
connector on the rear panel and switch on the Temperature Controller TTC001.
2) Press the Mode button to enter the Setup Menu and select the proper sensor type
from the "SEnSr" menu - see Section 4.3.3.
3) From the "An in" menu, select the type of Analog Input control you desire: "Pid"
for adjusting the set temperature, and "Curr" for directly controlling the current -
see Section 4.3.9.
4) Press the Mode button to switch back to the Monitor Mode.
5) Press the ENTER button to enable the TEC current output of the Temperature
Controller. TEC ON mode is indicated when the display stops flashing.
6) Apply an analog voltage to jack "TUNE IN" at the rear panel of the Temperature
Controller TTC001.
Note
. only slow variations of the temperature set value (<< 1 Hz) are possible via the
analog control input "TUNE IN".
