Page 27
16005-D03
T-Cube TEC Controller
4.4 Typical Operation of the Temperature Controller
1)Connect power to the TTC001 using the provided power
supply or by mounting in the hub system.
2)Connect the temperature sensor and TEC element to the
TEC OUTPUT terminal on the rear panel - see Section 3.3.2.
3)Press the Mode button to enter the Setup Menu. The top
menu item, "diSP", is shown.
4)Turn the OUTPUT Knob until "SEnSr" is displayed.
5)Press the Enter bu tton, then turn the OUTPUT knob to
select the correct sensor.
Note
. Select ‘Ad59 0’ for both
AD590 and AD592 .
6)Press Enter to save the sensor type.
7)Turn the OUTPUT Knob until ‘HI L’ is displayed then press
ENTER. Turn the OUTPUT knob to set the desired high
temperature limit, then press ENTER to save the setting.
8)Turn the OUTPUT Knob until ‘LO L’ is displayed then press
ENTER. Turn the OUT PUT knob to set the d esired low
temperature limit, then press ENTER to save the setting.