Rev A Nov 2017
Page 8
Chapter 3
Getting Started
3.2.2 Mounting Options
The T-Cube TEC Controller is shipped with a baseplate fitted, ready to be bolted to a
breadboard, optical table or similar surface.
If desired, the baseplate can be removed and the unit can be stood on rubber feet -
see Section 3.2.3.
For multiple cube systems, a 3-channel and 6-channel K-Cube Controller Hub
(KCH301 and KCH601). ) are also available - see Section 1.3. for further details. Full
instructions on the fitting and use of the controller hub are contained in the handbook
available at www.thorlabs.com.
3.2.3 Removing the Baseplate
The baseplate must be removed before the rubber feet (supplied) can be fitted, or the
unit is connected to the USB controller hub..
Fig. 3.1 Removing The Baseplate
1) Using a hexagon key, remove the bolts securing the unit to the baseplate. Retain
the bolts for future use if the baseplate is refitted.
2) Turn the unit upside down.
Caution
When siting the unit, it should be positioned so as not to impede the operation
of the control panel buttons.
Ensure that proper airflow is maintained to the rear and sides of the unit. Do not
obstruct the ventilation holes.
Detail A
Detail B
Baseplate removed and rubber feet fitted
Baseplate attachment screws
