Rev A Nov 2017
Page 30
Chapter 5
Operation - Tutorial
5.3 Typical Operation From the GUI Panel
1) Connect power to the TTC001 using the provided power supply or by mounting in
the hub system.
2) Connect the temperature sensor and TEC element to the TEC OUTPUT terminal
on the rear panel - see Section 3.3.2.
3) On the GUI panel, click the ‘Settings’ button to display the Settings panel, then
select the ‘
Advanced
’ tab as shown below.
Fig. 5.2 TTC001 TEC Controller Settings Panel
4) In the
Sensor Type
field, select the appropriate temperature sen sor for your
application.
5) In the
Current Limit
field, enter an appropriate current limit value.
6) Click OK.
7) On the GUI panel, select the desired display type. (actual temperature, current, or
difference between the actual temperature and the set temperature).
8) Click the TEC Enable button.
9) Click the Set Arrow and set the set point value. The GUI display should increment
and decrement accordingly.
