Appendix D
60
HA0378T Rev C Feb 2019
GetOutputLUTTrigParams
Gets the output voltage waveform (LUT) triggering
parameters.
GetOutputLUTValue
Gets a specific voltage output value in the voltage
waveform (LUT) table.
GetParentHWInfo
Gets the identification information of the host
controller.
GetPosOutput
Gets the piezo actuator extension in closed loop
mode.
GetPPCIOSettings
Gets the Input and Output parameters for the rear
panel BNC connectors.
GetPPCNotchParams
Gets parameters for the notch filters.
GetPPCPIDParams
Gets the PID parameters.
GetSlewRates
Gets the limits set for the rate of change of the drive
voltage.
GetVoltOutput
Gets the HV output voltage.
GetVoltPosDispMode
Gets the GUI display mode (voltage or position).
Identify
Identifies the controller by flashing unit LEDs.
LLGetDigIPs
Gets digital input states encoded in 32 bit integer.
LLGetStatusBits
Gets the controller status bits encoded in 32 bit
integer.
LLGetHostStatusBits
Gets the controller status bits encoded in 32 bit
integer.
LLSaveHWDefaults
Allows the current settings of the operation
parameters to be saved into the onboard 'Flash'
memory of the hardware unit.
LLSetGetDigOPs
Sets or Gets the user digital output bits encoded in
32 bit integer.
LLSetGetHostDigOPs
Sets or Gets the user digital output bits encoded in
32 bit integer.
LoadParamSet
Loads stored settings for specific controller.
SaveParamSet
Saves settings for a specific controller.
SetAmpFeedbackSig
Sets the feedback signal type (AC or DC).
SetControlMode
Sets the loop operating mode (open/closed).
SetForceSenseParams
Sets the force sensing mode parameters.
SetHWMode
Sets Piezo Amp or NanoTrak operating mode.
SetJogStepSize
Sets the jogging step size.
SetMaxOPVoltage
Sets the value for the maximum output in the range
0 to 150 V.