THOMSON DD10, Руководство по установке

Страница: 175 / 179

7. Notes about Connection and Operation for DVE Integration Digital Diamond
67
10.3 OPERATION
Press the Aux Bus selection DVE on the switcher control panels and select the de-
sired source to be manipulated via the DVE.
Note, that this DVE routing consists of a fill bus and a key bus.
The key signal is selected according to the assignment that is made within the ”cou-
ple” menu of the switcher (e.g.: selection of the fill signal ”Character Generator” in-
put 1 automatically selects the key signal ”Character Generator” input 2).
This can be overwritten by holding the key ”DVE” bus down and selecting another
key source.
Note, that the above described selection scheme is in many cases redun-
dant:
”FXLoop” allows to operate the DVE move, as if it was a wipe effect in the back-
ground, allowing to simplify the DVE integration dramatically:
Press ”DVE Loop” and the desired effect layer This determines whether the user
wants to move the DVE within the background or one of the keyers:
Select the DVE feed signal (i.e. select the next DVE signal) via the ME preset bus
or one of the Key Fill buses.
Selection of ”Preset” or ”Program” as feed signal determines whether the DVE se-
quence runs as it was programmed, or reverses its polarity.
Select the desired DVE sequence via the Wipe selection panel of the switcher (in
case of DD5 and DD10, this is done by switching the selection ”wipe 1, 2, mask”
off, in case of DD20 and DD30, this is indicated via an LED).
Select the transition type DVE within the transition module for the desired effect
layer (DD10/20/30).
Note, that the bus selection follows automatically.
The DVE sequence can now be moved by means of the fader arm, resp. runs auto-
matically by pressing the AUTO key.
Once the scaling is done, the sequence run time is independently selectable within
the transition module (just like a wipe effect).
Note, that a DVE can always be selected by one fader only, i.e. if the DVE is se-
lected as transition type for ME 1, it will not react within ME 2.
Note that restrictions for FXLoop apply within the DD30 in the PP stage, should this
stage be utilized with independent PVW outputs.
Source selection
Effect selection
Effect move