THOMSON DD10, Руководство по установке

Страница: 121 / 179

7. Description of the Interface Diamond digital
112
Each master control panel RPD-xx allows connection of up to four AUX panels to
the serial port (RS-422). Previously, the address has to be adjusted at each AUX
panel, adjusting at each of the four AUX panels another address.
Proceed as follows:
1. Remove on the rear of the panel the small cover cap, revealing a DIP switch
module with 8 switches.
2. Adjust the DIP switches 1 to 8 as follows:
(0 means switch OFF = downwards, 1 means switch ON = upwards)
Schalter 1 2 3 4 5 6 7 8
1. Panel 0 0 0 0 0 0 0 1
2. Panel 1 0 0 0 0 0 0 1 Is applicable up to
3. Panel 0 1 0 0 0 0 0 1 software DS0011F
4. Panel 1 1 0 0 0 0 0 1
From software version ”DS0011G” which replaces the under–monitor dis-
plays, the switches have to be set as follows:
Schalter 1 2 3 4 5 6 7 8
1. Panel 0 0 0 0 1 1 1 1
2. Panel 1 0 0 0 1 1 1 1
3. Panel 0 1 0 0 1 1 1 1
4. Panel 1 1 0 0 1 1 1 1
3. Fasten the cover cap.
4. Connect the panels among each other and with the serial port of the master
control panel. For this purpose, a 9-wire cable with 9-pin Sub-D connectors is
required (connected) by means of which the sockets MPK of the AUX panels
and the serial port of the master control panel are connected.
AUX-CP
MPK
AUX-CP
MPK
AUX-CP
MPK
AUX-CP
MPK
RPD 10
5. Apply 5V DC to the AUX panels.
6. Select the protocol AUX / UMD in the SETUP of the master control panel at
PORTP.
Installation