2-47
2
C2314
C2313
C2309
C2325
Assembly (cont’d)
7
Install the bearing housing bolts and torque to 46.5 ft
lbs. +/- 2 ft lbs. (63 Nm +/- 3 Nm) (fig. C2314)
DRIVE MOTOR 2.12
Small bearing
Bearing nut
9
Install a new seals to the intermediate plate. (fig.
C2325). Apply petroleum jelly to the cup seal to retain in
position.
Seals
8
Install the small bearing to the output shaft (fig.
C2313) in the following sequence:
a.
Apply pressure, 175 psi (12 bar), to the brake ports
to release the brakes.
b.
Press the bearing onto the output shaft with a force
of 780 pounds of force (350daN), while rotating the hous-
ing back and forth. Be sure to press only on the inner race
of the bearing.
c.
Remove the brake release pressure before remov -
ing the force acting on the bearing.
d.
Install the bearing nut and torque to 45 ft lbs. (60
Nm) Strike the nut with blows from a mandrel and ham-
mer to prevent the nut from loosening.
Housing bolts
Содержание 1300 ProTough
Страница 1: ...REPAIR MANUAL 135 137 153 1300 ProTough Publication No 49702 September 2004 THOMAS...
Страница 13: ...1 HYDRAULIC SCHEMATIC 1 1 1 3 C4475...
Страница 61: ...1 1 51 NOTES...
Страница 86: ...2 25 2 TANDEM PUMP PARTS DIAGRAM 2 11 C 2875 6 1 5 5 2 7 8 10 11 12 13 4 4 4 4 3 3 9 2 LN000500 onward shown...