Thermo Scientific Barnstead GenPure, Руководство по эксплуатации

Страница: 32 / 106

7
Installation
Start your system into operation
26 GenPure Thermo Scientific
6 Unscrew the fitting on the rinsing connector and
pull the hose 8mm or 0.31 inch o.d through the
fitting.
Then push the white o-ring over the hose and
screw the fitting back to the rinsing connector on
the system.
Make a gravity fall (pressure less) connection
from the system (connector 10 to the floor
drain). The drain to the sewer must be 1m or
1.07 yards above the rinsing water connector of
the unit.
R
Rinsing water
connector
White
o-ring
Hose 8mm
o.d
Fitting
7 Screw the final filter supplied, counter-clockwise
(see arrow in the picture) into the dispensing
valve outlet (R 1/4“ female thread).
Connector
for
Autoclave
final filter
Final filter
8 Assemble the power pack and make the voltage
connection to the GenPure system.
See under chapter “Wall mounting” on page 27 .
9 If applicable use the RS232 connector (7) to
connect the optional data printer. Open the
feedwater supply tap.
Only feedwater that has been pretreated by
reverse osmosis, ion exchange or distillation is to
be used!
Feedwater
connecting
kit
Step Action Figure