Thermo Scientific Barnstead GenPure, Руководство по эксплуатации

Страница: 27 / 106

Thermo Scientific GenPure 21
6
The Installation Area
Take the following criteria into consideration when selecting the installation area:
Feedwater pressure, not below 0.1 bar (1.45 PSI) and not above 6 bar (87 PSI).

The feedwater pressure must never exceed 6 bar. If it is higher than this, install an
additional external Pressure regulator.
• Minimum air tempe2°C.
• The surface on which the system is installed must be level and stable - not to exceed a maximum of
2% deviation from evenness is recommended.
• A smooth wall is required when the system is to be wall-mounted. Check the statics of the wall. It
must have sufficient load-bearing capacity (for system weight, see “Technical specifications” on
page 17 ).
• An atmospherically floor drain with a outer diameter of 63 mm or 2.48 inch (DN 50 tube) shall be
provided. When no floor drain is available, install a water watcher to protect against water damage
(only available for EU).Otherwise the manufacturer will not accept liability for any possible water
damage.
• Free run off to drain.

Unrestricted gravity flow to drain must be ensured!
• An electrical socket appropriate for the system (see “Technical specifications” on page 17 ).
• When installing the ultrapure water system, always ensure that there is adequate space all around
the unit (approx 30 cm / 11.81 inch) to ensure that ease of use or replacement of materials (e.g.
filter change, connection) is possible at all times
• Easy access for operation and control of the system.
• Water pre treated such as DI, RO or distillation water connection with 3/4 NPT male thread and
customer supplied shutoff valve.
The operator is obliged to ensure, that the installation of the water purification unit
and its operation are carried out in compliance with all national and international
guidelines, applicable and valid for the place of installation. If necessary, measures to
protect the drinking water have to be taken by installing appropriate components.