Thermo Scientific 1300 Series, Руководство пользователя

Страница: 38 / 130

1300 Series A2 4-7 Thermo Scientific
Section 4
Operation
Extended Periond
Shut-down
To shut down the unit:
1. Remove all samples from the chamber and store them properly.
2. Remove any accessories from the chamber, and clean and disinfect
them.
3. Clean and disinfect the chamber surfaces, work tray, and drain pan.
4. Turn the unit to standby mode by first closing the window. Then press
and hold the ON key until the indicators are off (the right indicator
segment of the display shows a dot to indicate that voltage is present).
Caution For safety reasons, the blowers can be switched off only when the
front window is closed.
s
If the device is not to be used or is to be stored for an extended period of
time, it must be completely decontaminated.
Warning To shut the device down, the sample chamber must be
disinfected completely and the plenum, including the filters, must be
decontaminated using the appropriate and authorized procedures.
s
1. After the device has been decontaminated, close the window
completely.
2. Disconnect the unit from the power source.
All components with the exception of the HEPA filters can be discarded
after having been thoroughly cleaned and decontaminated. The HEPA
filters must be discarded in accordance with the applicable national, state
and local regulations for special solid waste.
Warning As this unit can be used for processing and treating infectious
substances, it must be decontaminated prior to disposal, in accordance
with acceptable standards and procedures.
Unit Shut-down
Unit Disposal