TEXIO PSF-1200L, Инструкция по эксплуатации

Страница: 67 / 121

58
<Normal operation> <Sequence operation>
PRESET 1 Starts or gives a pause to operation. (
)
PRESET 2 Jumps to the step of the number one smaller
than the step number. ( )
PRESET 3 Jumps to the step of the number one larger
than the step number. ( )
OUTP
ＵＴ
Finishes sequence operation.
CAUTION
The OUTP
ＵＴ
key does not start sequence operation.
Use the PRESET 1 ( ) key to start sequence operation. Even if the
sequence function is activated and the
“
●
SEQUENCE LED
” is lit, the
sequence operation will not start unless the PRESET 1 ( ) key is pressed.
Other functions than the preset function work normally even when the
“
●
SEQUENCE LED
” is lit.
When the OUTP
ＵＴ
key is pressed during sequence operation, sequence
operation finishes. Note that completion of sequence operation is
different from deactivation of output in normal operation.
(4) Display in sequence operation is different from that in normal
operation. It is as shown below. When the ESC / DISP key is pressed
in sequence operation, the step number is displayed on the voltage
7-segment LED and the number of cycles is displayed on the
current 7-segment LED. Press the
ESC / DISP key again to return to
the set value display condition (or the output value display condition
while output is given).
Press
DISP
key
Step No.
Number of
cycles
Number of steps
Display 1 in sequence
operation
Display 2 in sequence
operation
(5) During sequence operation, the
“
●
SEQUENCE LED
” below
the PRESET key blinks, indicating that sequence operation is being
executed. To stop sequence operation halfway, press the OUTP
ＵＴ
key or deactivate the sequence function as shown in Section
“5-5-5.
Sequence function (05)
”.