TESTO 300 XXL, Инструкция по эксплуатации

Страница: 8 / 80

8
Preparation
Setting up connection to instrument
1. Connect the
testo 300 XXL
control unit
and the interface cable (Part no. 0409.0178) with a
serial interface (COMx) in your PC.
2. Switch on the control unit.
3. Start the Testo analysis software.
4. Select the “
New device”
dialog box from the
“
Instrument”
main menu. The “
New device setup
wizard
” dialog window opens.
5. Select the
testo 300 XXL
instrument driver and click on
“
Continue
”.
6. Select a free interface and click on “
Continue
”. The name of
the instrument driver is shown.
7. Click on “
Finish
” to set up
the connection to the control
unit. The instrument driver
appears in the directory. If you
wish to carry out changes, press
“
Back
” to return to the previous
pages.
8. You can select between the configuration for the
control unit or the analysis box in the
“
Select device”
window. The “Slave Mode”
is shown on the
testo 300 XXL
control unit
display. It is not possible to operate the control
unit keypad in this mode.
If the instrument is not connected, please check
the connection cable. Also check if the
configuration (COM1, COM2...) corresponds
to the interface in use.
If there are problems, close the programs which
have access to the serial interface.
testoterm's Comfort-Software
Datei Einstellungen Messen Ansicht Analyse
Hilfe
Diagramm 1
Skala 2
Zoom
Zoom
26
25
24
23
0:00
00:01:00
26
25
24
23
C
25.450