Terex Genie Z-80/60, Руководство оператора

Страница: 45 / 80

Fifth Edition • First Printing
Operator's Manual
Inspections
Part No. 1294418GT Z
®
-80/60 43
Test Limited Drive Speed
68 Press down the foot switch.
69 Raise the primary boom to 10° above
horizontal.
70 Slowly move the drive control handle to the full
drive position.
Result: The maximum achievable drive speed
with the primary boom raised should not
exceed 1 ft / 30 cm per second.
Note: Models with foam-filled tires will travel 40 ft /
12 m in 40 seconds. Models with high-flotation
tires will travel 40 ft / 12 m in 62 seconds.
71 Lower the primary boom to the stowed
position.
72 Extend the primary boom 4 ft / 1.2 m.
73 Slowly move the drive control handle to the full
drive position.
Result: The maximum achievable drive speed
with the primary boom extended should not
exceed 1 ft/30 cm per second.
Note: The machine will travel 40 ft / 12 m in
40 seconds.
74 Retract the primary boom to the stowed
position.
75 Raise the secondary boom to 10° above
horizontal.
76 Slowly move the drive control handle to the full
drive position.
Result: The maximum achievable drive speed
with the secondary boom raised should not
exceed 1 ft / 30 cm per second.
Note: Models with foam-filled tires will travel 40 ft /
12 m in 40 seconds. Models with high-flotation
tires will travel 40 ft / 12 m in 62 seconds.
77 Lower the secondary boom to the stowed
position.
If the drive speed with the primary or secondary
boom raised or the primary boom extended
exceeds 1 ft/30 cm per second, immediately tag
and remove the machine from service.
Test Drive Tilt Cutout
78 Press down the foot switch.
79 With the boom fully stowed, drive the machine
onto a slope where the chassis angle is
greater than 4.5° along the Y-Axis (front to
back).
Result: The machine should continue to drive.
80 Return to level ground and raise the primary
boom to approximately 10° above horizontal.
81 Drive the machine onto a slope where the
chassis angle is greater than 4.5° along the Y-
Axis (front to back).
Result: The machine should stop once the
machine reaches 4.5° of chassis tilt and the
alarm should sound at the platform controls.