Terex Genie Z-80/60, Руководство оператора

Страница: 40 / 80

Operator's Manual
Fifth Edition • First Printing
Inspections
38 Z
®
-80/60 Part No. 1294418GT
Test the Tilt Sensor
13 Press one of the LCD
screen control buttons until
TURNTABLE LEVEL
SENSOR X-DIRECTION
appears.
Result: The LCD screen should display the
angle in degrees.
14 Press the LCD screen control buttons until
TURNTABLE LEVEL SENSOR Y-DIRECTION
appears.
Result: The LCD screen should display the
angle in degrees.
15 Press the LCD screen control buttons until
PLATFORM LEVEL SENSOR DEGREES
appears.
Result: The LCD screen should display the
angle in degrees.
Test the Operating Envelope
16 Press the LCD screen
control buttons shown until
PRI BOOM ANGLE TO
GRAVITY is displayed.
17 Raise the primary boom and observe the LCD
screen.
Result: The primary boom should raise and
the LCD screen should display the primary
boom angle in degrees from 35 to 65. The
primary boom should stop when the screen
reads 65 degrees.
18 Lower the primary boom.
19 Simultaneously press the 2
LCD screen control buttons
shown to activate status
mode.
20 Press the LCD screen
control buttons shown until
SEC BOOM ANGLE is
displayed.
21 Press and hold the secondary boom up/extend
button.
Result: The secondary boom should raise and
the LCD screen should display:
=0
>0
>35
=65
The secondary boom should raise and then
extend. The secondary boom should not
extend until it is fully raised.
22 Press and hold the secondary boom
down/retract button.
Result: The secondary boom should fully
retract and then lower. The secondary boom
should not lower unless it is fully retracted.