Terex Genie Z-80/60, Руководство оператора

Страница: 44 / 80

Operator's Manual
Fifth Edition • First Printing
Inspections
42 Z
®
-80/60 Part No. 1294418GT
Test Drive and Braking
57 Press down the foot switch.
58 Slowly move the drive control handle in the
direction indicated by the blue arrow on the
control panel until the machine begins to
move, then return the handle to the center
position.
Result: The machine should move in the
direction that the blue arrow points on the
drive chassis, then come to an abrupt stop.
59 Slowly move the control handle in the direction
indicated by the yellow arrow on the control
panel until the machine begins to move, then
return the handle to the center position.
Result: The machine should move in the
direction that the yellow arrow points on the
drive chassis, then come to an abrupt stop.
Note: The brakes must be able to hold the
machine on any slope it is able to climb.
Test the Oscillating Axle (if equipped)
60 Start the engine from the platform controls.
61 Drive the right square-end tire up onto a 6 in /
15 cm block or curb.
Result: The three remaining tires should stay
in firm contact with the ground.
62 Drive the left square-end tire up onto a 6 in /
15 cm block or curb.
Result: The three remaining tires should stay
in firm contact with the ground.
63 Drive both square-end tires up onto a 6 in /
15 cm block or curb.
Result: The circle-end tires should stay in firm
contact with the ground.
Test the Drive Enable System
64 Press down the foot switch and lower the
boom to the stowed position.
65 Rotate the turntable until the primary boom
moves past one of the circle-end tires.
Result: The drive enable
indicator light should come
on and remain on while the
boom is anywhere in the
range shown.
66 Move the drive control handle off center.
Result: The drive function should not operate.
67 Push the drive enable button or move the
switch and slowly move the drive control
handle off center.
Result: The drive function should operate.
Note: When the drive enable system is in use, the
machine may drive in the opposite direction that
the drive and steer control handle is moved.
Use the color-coded direction
arrows on the platform controls
and the drive chassis to identify
the direction of travel.
If the drive control handle is not moved within two
seconds of moving the drive enable toggle switch,
the drive function will not operate.