Cyclone User Manual
15
Mounting the Enclosure
Make sure that the Unistrut rails are attached securely to
the 4 (or 6) M12 threaded sockets on the bottom of the
enclosure frame.
Set the Cyclovator to its horizontal position:
1.
Loosen the two locking knobs (a)
2.
Turn the crank handle (b) until the Cyclovator
saddle is horizontal
3.
Tighten the two locking knobs (a)
Align the channel spring nuts (c):
4.
The distance (E) between the channel nuts
should be the same as dimension E in the
installation page (the distance between centers
of the Unistrut channels)
5.
Loosen the channel nut
bolts and align the
channel nuts with their
long sides parallel with
the end of the
Cyclovator saddle:
6.
Carefully set the Cyclone enclosure on the
Cyclovator saddle, so that the channel nuts are
INSIDE the Unistrut rails.
7.
PUSH UP and tighten the four M12 channel nut
bolts, so that the channel nuts lock in the
Unistrut channels.
8.
Loosen the locking knobs and turn the crank
handle to test movement.
Unistrut Rails
(a)
(b)
(a)
(c)
(E)
Cyclovator Saddle
Cyclovator Base
