Cyclone User Manual
17
Cyclone Angle Mount Kit
The Angle Mount kit is a simple fixed mounting solution for up to two Cyclone enclosures with a tilt angle from 10-45°. Unlike
Cyclovator, once set, the tilt angle is fixed.
The Angle Mount kit may be used on the ground, with projection up to a building, or on a tall structure or flat roof, projecting
down.
Shooting up….
Shooting down…
Angle Mount kits are available in three sizes:
55.AM2 for Cyclone 210
–
305
55,AM3 for Cyclone 310, 314, 324
55.AM4 for Cyclone 320, 525
Check with Tempest for Cyclone models not shown here or custom versions.
In certain cases, it will be safe to stack two Cyclone enclosures on one Angle Mount kit. Please note:
•
Do not double-stack in exposed locations subject to high winds
•
Do not double stack portrait enclosures
•
Do not double stack if the tilt angle >30°
Angle Mount Kit Installation
Mark out the mounting pattern on the ground or substrate.
It is the same as the rigging points for the enclosure (see
Installation/Dimensions D and E above).
Use stainless steel hardware suited to the mounting
substrate, and in compliance with local construction codes to
mount the Unistrut rails securely to the substrate.
Use M12 or ½” hardware, 2 sets per Unistrut rail.
E
D
Mounting points (x 4)
