FlexSym
©
OLT-mini Installation and Turnup Guide
Page 23 of 35
CLI commands, parameters and options can be entered using abbreviations. The
abbreviations are specified with capitalization in the help listings and context menus.
For example, the wizard command is displayed in the help listing as
WIZard
. This case
convention indicates that the command can be invoked using either
wizard
or the
abbreviated form
wiz
.
The CLI also provides for tab completion to speed input. Usually, typing the first
character of the command, parameter or option and then pressing
T
AB will provide
command auto completion.
•
The wizard will prompt for all required turnup information. Valid choices for each
configuration item are displayed in parentheses with each prompt. The wizard
attempts to guide the user by providing a default value, shown in [brackets], at
the end of each prompt. To accept the default value press
E
NTER. Otherwise,
enter the appropriate value and press
E
NTER. The following information will be
collected by the wizard:
Number of Uplink Interfaces
Typically, it is best to configure only a single management interface during
turnup. Additional interfaces can be provisioned after the OLT has been added to
Panorama. Panorama enables configuration of all OLT elements, including some
items that are not configurable from the CLI. The goal of turnup is to initialize the
system such that Panorama can be used to complete configuration.
AID of Uplink Interface
Accept the system default (NET1). A Link Aggregate Group (LAG) or uplink
interface can have the values NET1..NET4 on the OLT-mini.
Number of Ports
The number of ports to be bundled in the uplink LAG. Up to four(4) ports are
allowed.
Enable Link Aggregation Control Protocol
Link Aggregation Control Protocol (LACP) is the standard protocol used to
manage the ports in a LAG. The LACP configuration for a LAG must be consistent
between both participants. If only one side has LACP enabled, the LAG will be
disabled and traffic will not flow.
