Tellabs FlexSym OLT-mini, Инструкция и руководство по установке

Страница: 7 / 35

FlexSym
©
OLT-mini Installation and Turnup Guide
Page 7 of 35
Site Preparation
•
Tools Required
•
OLT Part Numbers for Ordering
• OLT Laser Part Numbers
•
OLT-mini Power Requirements
•
OLT-mini Environmental Specifications
Tools Required
Installation of the OLT-mini will require the following tools:
•
Laptop Computer : A laptop computer is required for turnup of the OLT-mini and
proper configuration of the uplink interfaces.
• μUSB Cable : If connecting to the OLT- mini using the μUSB interface, you will
need a standard USB3 to μUSB cable. The OLT - mini has a built in μUSB to serial
converter, so nothing other than the cable is needed for turnup via this interface.
You will need a terminal program to access the serial interface of the OLT-mini if you
use the μUSB interface. Teraterm and putty are good open source options. Teraterm is
used for the examples in this document.
•
Copper SFP Module : If connecting to the OLT-mini using SSHv2, you will need a
copper SFP module to install into one of the OLT uplink ports.
You will need an SSHv2 terminal program if using SSHv2 to access the CLI and
configure the OLT-mini Turnup parameters. Teraterm and putty are good open source
options.
•
Power Wiring: If using DC wiring, 20 AWG wiring or better is recommended.
•
Uplink Lasers: Ensure you have purchased the appropriate Tellabs supported
Modules shown in the "OLT Laser Part Numbers" table shown below.
•
M6 or 7/32" Allen Wrench: The enclosure is opened using either an M6 or
7/32" Allen wrench.