BRILLANTE User Manual, 59300023, rev005
Configuring the BRILLANTE
•
17
Editing the SIGEN configuration file
If the PSI/SI Insertion is activated then the SIGEN
configuration file must be edited. Enter the editing mode by
typing:
pico –w si.conf
See the example of configuration file further in this document.
SIGEN configuration file sections
There is a detailed description below about each section found
in configuration file (
si.conf
). A tabulator separates each field
on a line. Fill in and edit the required parameters.
Lines marked with the character ‘#’ are comment lines and
doesn’t have any affect on configuration. Comment lines can be
used as many as needed to add configuration related
information.
syntax_version
Version of configuration file format.
Do
not change!
Server Name
User defined name of a server process
(
brilemm
) which receives the data. No
duplicate names are allowed in list.
IPaddr:Port
IP address and port of the where the data
shall be sent.
Client
ID
32-bit identifier which shall identify
uniquely each EMMG/PDG across all the
EMMGs/PDGs connected. In the case of
EMMs or other CA related data, the two
first bytes of the client id should be equal
to the two first bytes of the corresponding
CA system id.
Data Channel ID
16-bit identifier which uniquely identifies
a Private Data channel within a client ID.
This value is allocated by the user.
Server Name
Name of the server where the data will be
sent. This name has to be defined in
<SERVER_LIST> section otherwise an
error will be reported.
<HEADER>
<SERVER_LIST>
<TDT>
