BRILLANTE User Manual, 59300023, rev005 Establishing
a
Data Connection
•
10
The device reboots and it will take few minutes.
Login as system or admin again to proceed.
At this point the Ethernet connections with the new
configurations should be up and running. The connections with
PRESTO / VIVACE and the CAS can be verified by using the
ping command.
ping xxx.xxx.xx.x
(IP address to verify)
In a case of no reply, check the Ethernet connection cables and
the IP configuration and then reboot.
If a reply is received you are ready to proceed.
Command Prompt
monitor Starts
the
BRILLANTE monitor application.
bril
BRILLANTE Main Menu, start/stop/restart
application processes.
brilstart
Starts all processes of BRILLANTE application.
Processes are running in background.
brilkill
Kills all BRILLANTE application processes.
brilrestart First kills all processes and then restarts them to
background.
sig
SI Generator Menu, start/stop/restart sigen process.
redundance.sh
BRILLANTE 1+1 redundancy script to control
main and backup units,
for more details refer to the
‘BRILLANTE 1+1 backup in brief ’ -section in this document.
cfgrtr.sh Brillante
configurator menu. Edit and handle some
basic settings.
ppvrun
Run BRILLANTE Pay Per View extension
(refer to
the Pay Per View User Manual).
ifconfig Displays the status of the currently active
interfaces.
route
Show / Manipulate the IP routing table, for more
details type
man route
BRILLANTE
commands
