Teledyne GFC7001T, Руководство по эксплуатации, Страница: 43 / 312

Getting StartedTeledyne API – Model T300/T300M CO Analyzer
Teledyne Analytical Instruments 43
Figure 3-8: Analog In Connector
Pin assignments for the Analog In connector are presented in Table 3-4.
Table 3-4: Analog Input Pin Assignments
PIN DESCRIPTION
DAS
PARAMETER
1
1 Analog input # 1 AIN 1
2 Analog input # 2 AIN 2
3 Analog input # 3 AIN 3
4 Analog input # 4 AIN 4
5 Analog input # 5 AIN 5
6 Analog input # 6 AIN 6
7 Analog input # 7 AIN 7
8 Analog input # 8 AIN 8
GND Analog input Ground N/A
1
See Section 0 for details on setting up the DAS.
3.3.1.3. CONNECTING ANALOG OUTPUTS
The GFC7001T is equipped with several analog output channels accessible through a
connector on the back panel of the instrument. The standard configuration for these
outputs is mVDC. An optional current loop output is available for each.
When the instrument is in its default configuration, channels
A1
and
A2
output a signal
that is proportional to the CO concentration of the sample gas. Either can be used for
connecting the analog output signal to a chart recorder or for interfacing with a
datalogger.
Output
A3
is only used on the GFC7001T/GFC7001TM if the optional CO
2
or O
2
sensor
is installed.
Channel
A4
is special. It can be set by the user (see Section 5.9.8.1) to output any one
of the parameters accessible through the
<TST TST>
buttons of the units sample
display.
To access these signals attach a strip chart recorder and/or data-logger to the appropriate
analog output connections on the rear panel of the analyzer.