Teledyne CombiFlash Torrent, Руководство по установке

Страница: 10 / 30

CombiFlash Torrent Installation Guide
Note
When using the Foxy R2 High Flow fraction collector, the Torrent’s rear panel Ethernet connector
will be in use. Instead, connect the cable to the available Ethernet port on the last Foxy in the
chain.
Note
The Foxy R2 fraction collector does not support DHCP. If you are adding the Torrent with Foxy R2
fraction collectors to your organization’s network, a static IP address must be assigned to each
unit. Contact your IT department for assistance.
Note
Detailed information about networking the Torrent with one or more Foxys is provided in
Section 2.12.2 O
PTIONAL
F
OXY
R2 H
IGH
F
LOW
F
RACTION
C
OLLECTOR
.
2.7 Position the Torrent
After completing the various back panel connections, the Torrent can be moved to its
operating position. Turn the Torrent so that the operator can access all of the front view
features and controls. Use care not to damage the connections, cables and equipment while
moving the Torrent.
CAUTION
Ensure that the Combi Flash Torrent has at least 3 cm (1.25") of air space behind it for ventilation.
Determine where the solvent and waste containers will be located. Keep in mind that the
valve wash waste is located on the Torrent’s left side panel; diverter valve waste will come
from the fraction collector or fractionation valve, usually positioned on the right side of the
Torrent. If these will use a common waste container, determine the preferred location.
Note
A common waste container is recommended for waste level monitoring to prevent overfilling.
2.8 Connect Solvent Select Valve Plumbing
If a Solvent Select Valve is not being installed you can skip
this section and continue to Section 2.9. If a Solvent Select
Valve is to be installed with the Torrent or Torrent AQ it
should already be mounted.
1. Connect the preswaged end of black tubing (023050308)
to Torrent “B INLET”.
2. Loosen (but don’t remove) the nut and 2-piece ferrule
connected to the Solvent Select Valve port “TO TORRENT B
INLET”.
3. Place the free end of the black tubing into the port as far
as it will go and finger tighten the nut. Then use a wrench
to tighten for a n additional 1 and 1/4 turn.
4. a) Locate a nut (60-0923-015) and ferrule (60-0083-163) in
the accessory package (60-5249-002).
b) Insert the ferrule, narrow end first, into the Torrent “B
LEVEL”.
c) Loosely thread the nut onto the “B LEVEL” port.
d) Insert the clear air supply line (supplied with Solvent
Select Valve) into the “B LEVEL” port until it is fully seated.