SEECTOR User Manual
seector00.doc 27.04.00
13
The
ready
indicator shows the ready status for the selected source.
Sources can have a ready input connector and can be configured in
different ways.
The
on air
indicator shows that audio is floating through the channel.
Both the channel fader and the on-switch must be active to enable
the on air indicator and the audio channel.
An optional active chain selection will inhibit the on air indication if the
audio is not routed to an open output.
Remote start follows the on air indicator.
The
peak
indicator is on whenever the audio level in the channel is
above a level limit. The limit level is defined during configuration.
The conference
call
indicator indicates that a 1.9kHz call tone is
present on the conference input. For consoles without conference
systems the indicator has no effect.
The
auto
indicator is illuminated when a remote control system or a
preset changes the fader value to another position than the fader
knob value.
Channel PPM
All fader strips may have a separate PPM meter. This is a lower
quality meter with a range from -36dB to +12dB.
The main purpose of the meter is to enable the user to see that audio
is present on the input.
Channel dynamics meter (Large fader only)
A dynamics meter may be included in the fader strip showing the
amount of compression or expansion.
Fader section (Large fader)
•
Fader
•
Fader switch
•
Illuminated on switch
Level control section (Small fader)
•
Level rotary control
•
Light bar displaying the level setting
•
Illuminated on switch
Whenever the fader or light bar is in the extreme down position the
fader switch is off.
The on switch toggles the channel on and off.
The indicator in the on switch is an indication for the on switch setting.
In the user set-up menu several options shall be selected for the on
switch.
ON SWITCH ALWAYS ON
locks all on switches in their on position.
ON SWITCH OFF BY CLOSING FADER
. Whenever the fader is set
to its off position, the on switch is also switched off.
C
O
U
O
U
