Merging TLA700 Modules
38
TLA700 Series Logic Analyzer Installation Manual
Merge cable
Figure 25: Positioning the merge cable before installing the cover
6.
Push forward on the cover so that you insert the tab on the front edge of the
cover into the rear of the front subpanel. Make sure that the cover is fully
seated and there are no gaps between the front and rear chassis flanges; refer
to Figure 23 on page 35.
7.
While holding the cover in place, install the screws nearest the front of the
module to secure the cover to the chassis.
8.
Install the screws near the front of the module.
9.
Slide the rear panel on the chassis and install the rear panel screws.
10.
Install the top and bottom rear screws.
11.
Install the merge cable bracket so that the guide pins point into the module.
12.
Install and tighten the screws on the merge cable bracket.
13.
Verify that you have installed and tightened all screws on the module.
