Basic Installation
8
TLA700 Series Logic Analyzer Installation Manual
Most-significant
digit
Least-significant
digit
Figure 5: Logical address switches (set to address FF)
You can merge modules together to create wider modules. If your application
requires you to merge modules, refer to
Merging TLA700 Modules
(beginning on
page 25) for the merge instructions before continuing with this section.
You can install any of the modules in any slot that the module key will allow;
see Figure 7 on page 11. If you intend to merge the modules, refer to the merging
modules rules on page 25. If you are not merging the modules follow these
guidelines:
H
Install a single module in slots 3--4. Place a double-width slot cover over
slots 1--2.
H
When installing a logic analyzer module with an oscilloscope module, install
the oscilloscope module in slots 1--2, and the logic analyzer module in
slots 3--4.
Use a screwdriver to tighten the retaining screws to 2.5 in-lbs after seating the
modules in place. See Figure 6 on page 10.
Merging Modules
Installing Modules in the
TLA715 Portable
Mainframe
