7
Using Fonts and SCSI Hard Disks
7-14
Phaser 220 Color Printers
Enabling and disabling Sys/Start Job execution
The following Þles control Sys/Start Job execution and apply only to the
Phaser 220i.
■
The
Set SysStart Job
(
SYSTART.PS
) Þle enables automatic execution
of a Þle named
SysStart
(if one is found) on a hard disk connected
to the printer's SCSI port, each time the printer is turned on or
reset. The Sys/Start job is similar to an Init Þle; it executes
automatically each time the printer is switched on.
■
The
No SysStart Job
(
NOSYSTRT.PS
) Þle disables automatic
execution of the Sys/Start job.
Send one of these Þles to the printer to control Sys/Start Job execution.
*Available only on the Phaser 220i.
Note
Switch 5 on the printer's rear panel affects the operation of these
Þles. If Switch 5 is
up
, Sys/Start Þles are bypassed; if Switch 5 is
down
, you can use these Þles to control Sys/Start execution.
Macintosh users
1.
The
Sys/Start Job
Þles are compressed into the
Phaser 220
Utilities.sea
archive Þle on the Macintosh Printer Utilities diskette,
and must be decompressed before you can use them. To
decompress these Þles, follow the steps listed under the topic
ÒDecompressing the Macintosh utility ÞlesÓ in Chapter 1, ÒBefore
You Begin.Ó After decompressing these Þles, continue with the
steps listed below.
2.
Select the appropriate printer in the
Chooser
.
3.
Locate the Sys/Start Job Þles in the folder on your hard disk
containing decompressed utility Þles.
Macintosh file name
PC file name
Set SysStart Job*
No SysStart Job*
SYSTART.PS*
NOSYSTRT.PS*
Содержание Phaser 220
Страница 1: ...Printing Reference Phaser 220 Drivers and Utilities First printing December 1993 070 8870 00 ...
Страница 3: ...Printing Reference Phaser 220 Drivers and Utilities First printing December 1993 070 8870 00 ...
Страница 132: ...7 Using Fonts and SCSI Hard Disks 7 16 Phaser 220 Color Printers ...
