ENGLISH
ATA Energy Storage System MM
19
User’s manual
9.5
Operation in Fault Mode
When
Fault
led illuminates and the buzzer beeps continuously, it means that there is a fatal error in the ATA. Users
can get the
Fault code
from display panel. Please check the “Troubleshooting” chapter for details.
Please check the loads, wiring, ventilation, mains supply, PC supply, Battery and so on after the fault occurs. Don’t try
to turn ON the ATA again before solving the problems. If the problems can’t be fixed, please contact Technical Service
immediately.
In case of emergency, please disconnect the connection from mains supply, PV supply,
external Battery, and Output immediately to avoid further risk or danger.
Below you can see the “Fault Table”, with each Fault event and the relative FAULT code/icon on graphic LCD for the
user’s information.
FAULT EVENT
FAULT CODE
ICON
FAULT EVENT
FAULT CODE
ICON
Fan is locked when inverter
is off.
01
Main relay failed
11
Over temperature
02
Over current or surge
51
Battery voltage is too high
03
Bus voltage is too low
52
Battery voltage is too low
04
Inverter soft start failed
53
Output short circuited or
over temperature is
detected by internal
converter components.
05
Over DC voltage in AC output
55
Output voltage is too high.
06
Battery connection is open
56
Overload time out
07
Current sensor failed
57
Bus voltage is too high
08
Output voltage is too low
58
Bus soft start failed
09
Fault Table
Содержание ATA 4.0 MM
Страница 2: ......
Страница 64: ...ENGLISH User s manual 58 ATA Energy Storage System MM...
Страница 123: ......
Страница 124: ...TECNOWARE s r l www tecnoware com...