TECNOELETTRA s.r.l.
via D.Vioni n.5 – 42016 S. Rocco - Guastalla (RE) Tel.+39.0522.832004 Fax.+39.0522.832012
mail:
web:
www.tecnoelettra.it
Cod. doc. MT2550038-rev.1.0-IT-GB.doc
32 / 56
- During work it is recommended to keep to the current personal safety rules in force in the country the product is destined for (clothing, work tools,
etc.).
- When the unit is working do not use the electric control board parts.
- Never for any reason modify any part of the electric panel (connections, holes, electrical or mechanical devices, etc.) unless duly authorized to do
so in writing by “
TECNOELETTRA
”: the responsibility deriving from any such action shall fall on the person doing it since he then in fact becomes
its manufacturer.
- Before doing any cleaning or maintenance,
de-energise
and switch off the machine it is connected to.
-
De-energise and disconnect the equipment in the event of breakdown or malfunction. If any repairs is needed contact an
Authorized Retailer
only and ask that only original spare parts are used
. Failing to observe the above instructions may put the safety of the electric control board
at risk and the warranty will immediately decline.
-
When installing the control panel comply with the IP protection seal indicated on the identification plate. If the IP protection seal is not indicated
and for different kinds of "IP" protections diverse contact one of our service centres or contact our technical office directly.
- Make sure that earthing complies with the standards in force in the country in which the appliance is used.
- Check that control panels that are installed on the machine are not subjected to vibrations that could damage the parts.
N.B.: The panel size depends on an ambient temperature of 35 degrees Centigrade.
- As a consequence, please make sure that these levels are complied with. As concerns atmospheric conditions, the prescriptions contained in the
CEI EN 60439-1 (6.1.2) have to be complied with.
- Check that the information on the control panel identification plate is compatible with appliance ratings such as voltage, current, frequency, etc.
- If the control panel can be locked, make sure that only authorised personnel can use the key to open the control panel.
- For the protection of inlet lines are not protected comply strictly with the regulations in force in the country in which the control panel is used.
- If the control panel is fitted with guards that need to be removed to wire up the control panel, make sure that they are refitted after the control
panel has been wired up. Make sure that the control panel is disconnected and locked out during these operations and that no parts carry
residual current.
- Strictly follow the wiring diagram that accompanies the control panel.
- The manufacturer declines any responsability into following cases:
a) misuse of the machine or use by persons not trained for its operation.
b) incorrect installation.
c) operating faults machine is applied who to electric control board.
d) serious lack of due maintenance.
e) unauthorized modifications or servicing.
f) use of non-original or non-specific spare parts for the model.
g) total or partial failure to follow the instruction.
h) Exceptional events ect.
The panels’ interruption power is 10 kA. For more powerful systems, please make sure that the right protection levels in the panel inlet lines are
supplied.
The instruction manual can never substitute a sufficiently experienced user.
Warning
: This booklet is not binding. “
TECNOELETTRA
” reserves the right, without prejudice to the essential
features of the model herein described and illustrated, to make improvements and modifications to parts and accessories
without moreover undertaking to update this manual in time.
1.3 - Symbols in the manual
The symbols contained in this manual have the purpose of drawing the user’s attention in order to prevent trouble or danger both for persons and
objects or the equipment.
These symbols moreover have the purpose of drawing your attention in order to indicate correct use and obtain good operation from your electric
panel.
