TECNOELETTRA s.r.l.
via D.Vioni n.5 – 42016 S. Rocco - Guastalla (RE) Tel.+39.0522.832004 Fax.+39.0522.832012
mail:
web:
www.tecnoelettra.it
Cod. doc. MT2550038-rev.1.0-IT-GB.doc
31 / 56
1 - GENERAL
The Instruction for Use are integral part of the machine and must accompany it for all its useful life until its demolition.
For every operation one must always apply to what is prescribed in the Instructions.
Follow scrupolously all indication reported in the Instructions
Prevent from making use of the machine operators not knowing the prescription based on the Instructions
Keep complete and legible Instructions in a place accessible to operators.
Hand over the manual to any other user or successive owner of the machine.
Verify if the registration number reproduced on the technical card of the acquired model agrees with that one cut with the label of the “Marking CE”
The Firm “
TECNOELETTRA s.r.l.
” will not think he is responsible for difficulties, breaks, accidents etc. due to the no knowledge or at any rate to the
no application of the rules held in this manual.
The same is told for the execution of changes and variants or for the installation of accessory not previously authorized.
1.1 - Introduction
Dear Customer,
We would like to thank you for your attention and for purchasing a “
TECNOELETTRA
” high-quality “Electric Panel.”
Our Technical Service and Spare Parts departments will do their utmost to help you should you need it.
To this regard, for all control and overhaul operations, please call “
TECNOELETTRA
” who will provide you with specialized, prompt action.
If you have had parts replaced, ask and make sure that only genuine “
TECNOELETTRA
” spare parts are used in order to assure you that the initial
performance and safety required by current standards are restored.
Use of
non-genuine spare parts shall immediately forfeit all right to warranty
and Technical Service by “
TECNOELETTRA
”.
The special composition and design of this panel enables satisfying the most restrictive operator safety standards.
To use “
TECNOELETTRA Electric Panels
” in the best way, below we give the most important rules to be followed.
1.2 - General warning
- This manual has been drawn up for the
USER
, the
MAINTENANCE TECHNICIAN
, the
REPAIRS TECHNICIAN
.
- Read this manual carefully since it server as a guide to the way the electric control board is designed to be used, to its technical features, to
supply the instructions for installation, assembly, regulation and use. It is also useful for personnel training, to indicate the maintenance
operations, for ordering spare parts and to give indications of the outstanding hazards.
- It is wise to remember that should any difficulty arise in its use, installation or whatever, our Technical Service is always at your disposal for any
explanations or action.
- The instruction manual should be considered as part of the equipment and must be "
KEPT FOR FUTURE REFERENCE
" as long as the
equipment is assembled.
- The manual must always be available for consultation near the electric control board and kept in a suitable manner (in protected, dry places,
away from direct sunlight, etc.).
- It should be borne in mind that some diagrams it contains have only the purpose of identifying the parts described and therefore might not
correspond to your machine.
- After opening the package, check the entire unit in case of problems with this unit do not use it until you have consulted an the
Retailer or
Manufacturer
otherwise all warranty rights will be voided.
- This electric panel has only to be used for the purpose for which it was specifically designed. Any other use shall be considered improper and,
therefore, dangerous.
- Our products are made in conformity with current safety standards so it is recommended to use all these devices and take care that their use
causes no injury or damage.
- All operations concerning the installation of the control panel should be carried out by skilled personnel in conformity with present regulations.
