TECNOELETTRA s.r.l.
via D.Vioni n.5 – 42016 S. Rocco - Guastalla (RE) Tel.+39.0522.832004 Fax.+39.0522.832012
mail:
web:
www.tecnoelettra.it
Cod. doc. MT2550038-rev.1.0-IT-GB.doc
35 / 56
1.11 - Disposal
After use or in the case of demolition, the appliance must be disposed of according to the legislative provisions in force in the country it is destined
for.
CAUTION!
In addition, it is wise to destroy the machine’s identification plate and any other documents.
1.12 - Service center
All maintenance work and technical service must be performed by “
Specialized personnel
” authorized by “
TECNOELETTRA
” who will arrange for
a technician to step in after the customer’s call.
1.13 - Repairs and spare parts
For any further inconveniences, not mentioned in this booklet or any demages of the machine, we suggest you to go to the Retailer or Manufacturer
for the repair or possible replacement of any original spare parts.
When requesting spare parts, always:
- Indicate serial number.
- Indicate abbreviation that is stamped onto the part.
Do not wait for the components to be worn out.
Replacing a component at the right moment means to improve the electric control board operation and at the same time avoid
greater damages.
1.14 - Warranty conditions
See document n.5159 at the end of this section of the instruction manual
1.15 - Ordering spare parts
The spare parts orders must be accompanied with following indications:
- Serial number of the board.
- Letter/code stamped on the component to be replaced.
Due to the different types of product, it is not possible to enclose drawings of spare parts. They need to be requested with the serial number of the
board and the code of each single component.
2 - FIRST STARTING OF THE TE805 BOARD, USE AND DESCRIPTION
This product permits to control all the functions about a generator
Engine commands and protection module for diesel or gasoline generators
Measurement system for main electric values
Automatic control module for two different supply sources (Automatic Mains Failure)
Automatic changeover switch commands for two different supply sources (Automatic Transfer Switch)
It’s builded to monitor mono-phase, tri-phase or tri-phase with neutral systems in alternate current; it permits to transfer the user’s load on generator
when the mains voltage is faulty.
2.1 - Operation to do during the first starting of the TE805 Board
During the first start up, the electronic board is automatically in OFF / RESET mode. If you need to store the same mode operation mode before
shutdown, you must change the parameter 02.11 in GENERAL menu. The board can be powered either indifferently 12 and 24Vdc, but needs the
proper setting voltage battery in BATTERY menu, otherwise there will be an alarm on the battery voltage. It is essential to set the parameters of the
GENERAL menu (CT ratio, type of connection, rated voltage, frequency of the system) and the ENGINE START and ENGINE CONTROL menu
relating to the type of engine used.
The non observance of the indications given about the first starting of the product, can cause faulty situations on the same
product
Before the first starting of the panel, check that the indications on the “Identification data plate” (par. 3.1) are in accordance with
the characteristics of the present electrical system.
It is strongly reccomended to program the time
