2
INFORMATION FOR SAFETY
2.1. USING THIS MANUAL
The generic information of the equipment is supplied in soft copy on technovision official website, and it
includes among other documents the own user's manual of the system and the document concerning to
«Safety instructions». Before doing any action over the equipment regarding Operational, installation or
commissioning, change of location, setting or handling, read them carefully. This user's manual is intended
to provide information regarding the safety and to give explanations about the procedures for the
installation and operating of the equipment. Read them carefully and follow the stated steps in the
established order
Compliance as regards to “Safety instructions “is mandatory, being the user the legal responsible
regarding to its observance and application.
Prevent
exposure
to
the
elements
and
do
not
allow
water
. To enter the Stabilizer. Please installed the indoors.
Avoid wearing jewelry during installation.
Power connections must remain tight to avoid excessive heating from a loose connection.
Use properly sized conductors and circuit breakers input and output side refer table no.6.
The grounding terminal is located in the wiring compartment and is identified by the symbol
below.
This Stabilizer is to be connected to AC circuits only. These AC connections are identified by the
. Symbol below: Input and Output side also AC Supply.
If you received any damaged material during transportation on your side please contact
technovision technical support team before installing stabilizer.
If you find any loose connection because transportation please tighten the connection before
. Commissioning.
Chapter
2