32
ENTER key to save current value & go to next parameter. To return on GENERAL SETTINGS screen at any
moment press the BACK key. For returning to the RUN mode from the GENERAL SETTINGS screen press
the BACK key again.
P a rameter
D e s c r ip t io n
R a n g e s
Set Volt
Set voltage
100-999V
Vout High
Output high voltage limit
100-999V
Vout Low
Output low voltage limit
100-999V
Vin High
Input high voltage limit
100-999V
Vin Low
Input low voltage limit
100-999V
Tcut HV
High voltage cut off time limit for Output & Input
0-999S
Tcut LV
Low voltage cut off time limit for Output & Input
0-999S
Tcut Ph
Cut off time limit for PH. REV & PH. FAIL
0-999S
ON Delay
Auto start delay
0-999S
Sensitivity
Sensitivity
1-25V
Hysteresis
Hysteresis
1-25V
Auto/Man
Auto ON after error condition is cleared
Auto/Manual
Phase Rev
Phase reverse protection
Yes/No
Ph. Fail
Phase fail protection
Yes/No
Scrolling
Scrolls display
Yes/No
Beep Alert
Buzzer alert on error
Yes/No
7.7.4 Change User Password:
Upon pressing the STOP key on Change User Pwd, user interface will ask for a 4 -digit password. Each digit must
be set using START/STOP keys and confirmed using ENTER key. After entering the new 4 -digit password, the
password will be updated. To return on GENERAL SETTINGS screen press the BACK key & for changing the next
parameter press the ENTER key.
7.7.5 Disable User Password:
To disable User Password long press the STOP key on Change User Pwd screen, the password will be disabled
.
