17
INSTALLATION
Read and respect the Safety Information, described in section 2 of this document. To
obviate some of the indications described in it, can cause serious or very serious injuries to the
persons in direct contact or in the vicinity, as well as faults in the equipment and/or loads
connected to itself.
Check that data in the nameplate are the required ones by the installation.
A wrong connection or maneuvering, can cause faults in the stabilizer and/or loads connected to
it. Read the instructions of this manual carefully and follow the stated steps in the established
order.
The equipment must be installed by qualified personnel and it can be used by personnel
with not specific training, just with only help of this «User's manual».
Any connection of the equipment, including the control (interface, remote control ...), will
be done with all the switches in rest and no mains present (power supply switch of the equipment
turned «Off»).
5.1 TO CONSIDER IN THE INSTALLATION
The equipment’s have terminals for its input and output connections. Nevertheless some models
due to their high power rate, the power supply cable connection is directly done in the own
terminals of the input switch or breaker, when they have rods.
As regards to the protective earth connection and earth bonding connection, the equipment’s
have an earth terminal or stud, less those double cabinets, which will have two earth connection
points by means of studs, one for the main protective earth cable and the other one for the earth
bonding for the load or loads.
The nameplate of the equipment contents the maximum input current (corresponding to the
nominal power with low voltage regulation) and the nominal output. The efficiency of the
equipment has been considered to calculate the input current
Overload condition is considered as a nonpermanent and exceptional way.
In case peripheral elements are added at the input or output like transformers or
autotransformers, The current of the nameplates of these elements has to be considered in order
Chapter
5