➢
Operation mode
•
Off
–
Selecting this option disables the floor heating mode, i.e.
Floor Protection
nor
Comfort Mode
are not active.
•
Floor protection
–
This function is used to keep the floor temperature below the set maximum temperature to
protect the system from overheating. When the temperature rises to the set maximum temperature, the reheating
of the zone will be switched off.
•
Comfort mode
–
This function is used to maintain a comfortable floor temperature, i.e. the controller will monitor
the current temperature. When the temperature rises to the set maximum temperature, the zone heating will be
switched off to protect the system from overheating. When the floor temperature drops below the set minimum
temperature, the zone reheat will be switched back on.
➢
Min. temperature
The function is used to set the minimum temperature to protect the floor from cooling down. When the floor
temperature drops below the set minimum temperature, the zone reheat will be switched back on. This function is only
available when you select
Comfort Mode
.
➢
Max. temperature
The maximum floor temperature is the floor temperature threshold above which the controller will switch off the
heating regardless of the current room temperature. This function protects the installation from overheating.
4.2.
ADDITIONAL CONTACTS
The function allows you to handle additional contacts. First of all, it is necessary to register such a contact (1-6 pcs.). To do
this, select the
Registration
option and briefly press the communication button on the device, e.g. MW-1.
After registering and switching on the device, the following functions will appear:
➢
Information
- information about the status, operating mode and contact range is displayed on the controller screen
➢
On
- option to enable/disable contact operation
➢
Operating mode
–
user available option to activate the selected contact operation mode
➢
Time mode
–
the function allows setting the contact operation time for a specific time
The user can change the contact status by selecting/deselecting the
Active
option
and then setting
the
Duration
of
this mode
➢
Constant mode
–
the function allows setting the contact to operate permanently. It is possible to change the contact
status by selecting/deselecting the
Active
option
➢
Relays
–
the contact works according to the zones to which it has been assigned
➢
Dehumidification
–
if the
Maximum Humidity is exceeded in a given zone,
this
option allows you to start the air
dryer
➢
Schedule settings
–
the function allows you to set a separate contact operation schedule (regardless of the status
of the controller zones).
CAUTION
The
Dehumidification
function works only in the
Cooling
operation mode.
➢
Delete
–
this option is used to delete the selected contact.
