6-63
6. DIAG. TEST OPERATION
EO18-33006
6.5.2 Black Mark Sensor Adjustment
Black mark sensor setting should be performed after replacing the CPU PC board or changing the
tag paper to other maker’s one, or when a paper feed error occurs.
6.5 SENSOR SETTING MODE
NOTES: 1. Make sure to adjust the black mark sensor using the white part of the tag paper as a criterion.
Though an adjustment can be performed with the black mark, it may cause a paper jam
error.
2. Pressing the [PAUSE] key validates the sensor adjustment. The value of the sensor is
displayed up to 5.0 V.
Power off
Turn on the power while holding down
the [FEED] key and [PAUSE] key.
Press the [FEED] key three times.
Set the tag paper so that the black mark
sensor can detect the white part of the
tag paper. (See NOTE 1.)
The former value is displayed.
Holding the [FEED] key or [RESTART]
key down until an asterisk ( * ) is
displayed. (More than 3 seconds.)
Indicates the completion of adjustment.
Ex)
Press the [PAUSE] key twice.
Press the [PAUSE] key for Feed Gap Sensor Setting.
Align the white part of the TOSHIBA TEC
specified tag paper with the black
mark sensor.
(See NOTE 2.)
Black Mark
Tag paper
Black Mark
White part
Black Mark Sensor
Press the [FEED] key
and [RESTART] key at
the same time.
[ R
F L E C T I V E ]
E
3 . 8 *
< 1
D I A G N O S T I C V
>
1 . 0 A
< 4
S E N S O R A D J U S T
>
M E N T
[ R
F L E C T I V E ] 2
E
. 8 V
