6-40
6. DIAG. TEST OPERATION
EO18-33006
6.3.18 Ribbon Type Selection
6.3 PARAMETER SETTING MODE
NOTES: 1. Holding the [FEED] key or [RESTART] key down for more than 0.5 seconds enables a fast
forward.
2. Non-transmissive (NON TRANS.) ribbon cannot be used so the ribbon type must be set to
transmissive (TRANS.) ribbon.
3. A changed ribbon type is stored in memory by pressing the [PAUSE] key.
Power off
Turn on the power while
holding down the [FEED]
key and [PAUSE] key.
Press the [FEED] key.
Press the [PAUSE] key 19 times.
Select either ribbon type with
the [FEED] key or [RESTART]
key. (See NOTE 1and 2.)
Press the [RESTART]
key. (See NOTE 3.)
Press the [PAUSE] key.
Continued on Section 6.3.19
Ribbon Motor Drive Voltage
Fine Adjustment.
Transmissive ribbon
Transmissive: With ribbon
Non-transmissive: Ribbon end
Non-transmissive ribbon
Transmissive: Ribbon end
Non-transmissive: With ribbon
< 1
D I A G N O S T I C V
>
1 . 0 A
R I
B O N N O N T
B
R A N S
< 2
P A R A M E T E R S E T
>
