3-3
EO18-33006
3. INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT
s
t
r
a
P
d
e
v
o
m
e
R
t
i
n
U
/
y
t
'
Q
s
t
r
a
P
d
e
v
o
m
e
R
t
i
n
U
/
y
t
'
Q
e
t
a
l
p
t
n
o
r
F
1
)
6
x
4
-
L
F
(
w
e
r
c
S
3
3.1 CUTTER MODULE (B-4208-QM)
10) Mount the operation panel and the left side cover on the printer.
11) Close the top and right covers.
12) After reassembly is complete, perform a test print to confirm that the cutter works properly. If the print
start position becomes misalign when media is fed in the reverse direction, fine adjust the back feed
value using the Back Feed Fine Adjustment procedure in diag. mode.
NOTE:
Retain the parts that are removed during installation of the cutter unit. They will be required
when the printer is modified to a standard type.
■
Adjusting the Cutter Guide Plates
After replacing the cutter unit the following adjustment procedure should be employed to prevent
paper jams.
1.
Attach the cutter guide plate A with two SM-4 x 6C screw so that the fixed cutter is positioned
0.1 mm to 0.4 mm above the bottom of the cutter guide plate A.
2.
Attach the cutter guide plate B with two FL-4 x 8 screws so that there is a clearance of 0.5 mm
between the cutter guide plate A and cutter guide plate B using a clearance gauge.
Fixed Cutter
Screw
(SM-4 x 6)
Cutter Guide Plate B
Cutter Guide Plate A
Screw
(FL-4 x 8)
Fig. 3-5
0.1 ~ 0.4 mm
0.5 mm
