R
2800 LAURA LANE • MIDDLETON, WI 53562 • (800) 288-9383 • FAX (608) 836-9044 • www.tcsbasys.com
3
Setup
Note:
If using remote sensor(s), the calibration may need to
be adjusted. See “Checkout & Troubleshooting” section.
SENSOR SELECTION
The dipswitches in the cover (shown above connected with
ribbon cable) as well as the program must be set when using
remote room and/or discharge. Use the following guide to
determine the dipswitch settings for your application.
Using built-in room sensor only.
(This is the default setting.)
Using built-in room sensor with
discharge air sensor.
Using remote room sensor only.
Using remote room sensor with
discharge air sensor.
1 2 3 4 5
1 2 3 4 5
KEYPAD ACCESS
The dipswitches in the cover (shown above connected with
ribbon cable) must be set in order to lock the user out of the
program and/or to set the clock and schedule. Use the guide
below to set these dipswitches for your application.
Otherwise, user access may be limited with an access code
set in programming. (The fan and system switches are
enabled or disabled in programming only, and require no
dipswitch placement.)
Keypad access to both
programming and clock setup.
(This is the default setting.)
No keypad access to programming
or clock setup.
Keypad access to programming
only.
Keypad access to clock setup only.
Once the dipswitches have been set and you have confirmed
that the sensors are reading correctly (and program and clock
setup are finished, if locking out access with dipswitches),
secure the cover to the base with the two set screws located at
the top right and the left side to prevent tampering.
