MOUNTING OF PLASTIC FILM
When loading a plastic roll, first ensure the Top
Cone is pushed up to the latched position, then
push back the Dispenser Insert until held in
position by the Bottom Latch.
Place the Roll on the Bottom Cone and release
the Top Latch.
BEWARE OF FINGERS!
Pull the film between the rollers on the
Dispenser Insert in the direction of the arrow,
as shown below. (See also the sticker on the
dispenser).
Release the Bottom Latch and allow the rollers
to lie against the roll of film. Pull the film from
the roll and tie it to the bale.
TANCO DUAL STRETCH DISPENSER
All Tanco Autowrap machines are supplied with a patented dual stretch gear
system. This system enables a quick change of stretch levels on the Film
Dispenser.
If the Gear Bolt is fitted in Position 1, the top set of gears provide the stretch @
70%.
By removing the Gear Bolt from Position 1 and fitting it in Position 2, the
bottom set of gears become the stretch gears giving 32% (for prestretched film)
or optionally 55% (for use in hotter climates or with square bales).
MACHINE
SETUP
1
Top Latch
2
Top Cone
3
Dispenser Insert
4
Bottom Cone
5
Insert Plunger
1
2
3
4
5
Tanco Dispenser Gear Comninations
Inner Gear Outer Gear % Stretch
60 Tooth
35 Tooth
70%
58 Tooth
37 Tooth
55%
54 Tooth
41 Tooth
32%
A100 EH Operator’s Manual
20 //
49
