CONTROLLER
INFORMATION
Selecting a Store Total
There are 10 individual memory registers labeled ‘Store A’ to ‘Store J’ for bale totals. Each time
a bale cycle is completed, the currently selected store total and the grand total increments by
1.
The currently selected store is displayed on one of the two screens selectable in the normal
operating mode. The default setting is Store A. To select a particular store, navigate the
display menu using the 4-way switch. Press the Up/Down arrow keys to select the store, then
press the ENTER key to confirm the selection.
Resetting a Store Total to Zero
Stores A to J can be individually reset to zero at any time. The Grand Total store cannot be
reset. First select the store to be zeroed, and then navigate the display menu. Press the ENTER
key to reset.
Setting the Number of Wraps
The default number of wraps is 16. You can set the target number from 0 to 99 by navigating
the display menu as shown below. If you require 24 wraps navigate the menu and
increment the Default value to 24.
To Set Wraps
16
Use To Set
6
O - 99
Operator
Setup
Technician
Setup
Enter Pin
OOOO
Time Durations
Time Delays
Controller Configurations (e.g. Language)
Auto Settings (e.g. Autoload, Autostart Wrap,
Auto Off-Load)
Diagnostic Screens
[Keep down srrow pressed until screen changes]
A100 EH Operator’s Manual
29 //
49
