Takeuchi TB175W, Руководство по ремонту

Страница: 851 / 851

9
TB175W Maintenance software Ver1.0, Error Code Table
Error Code Discription Note
01
Key SW starter signal and start
operation for a short time.
Key switch starter signal was entered in less than 2 seconds
interval.
PULL action of Engine Stop solenoid was repeated in short
interval.
02
Engine oil pressure decrease
after
engine starts
03
After the engine starts,
Alternator
charge is defective
04 Overheating Signal from water temperature switch
06 Air cleaner stopped up
07 Lift over load
Lifting overload appeared (more than 1second) after ACC power
supply
10
Glow key SW turning on for a long
Time
Glow key switch had connected more than 10 seconds.
11 Ignition at time of head Glow Glow had ignited more than 10 seconds.
12
The upper bound of voltage of the
battery is abnormal
Voltage as over 29V had been measured over 0.5 second, after ACC
power was supplied or engine was started.
13
the lower bound of voltage of the
battery is abnormal
Voltage as under 16V had been measured over 2 second, after ACC
power was supplied or engine was started.
15 Clock initialization
Clock in the controller had been reset.
For example, It will happen when Battery have abnormal lower
voltage in
16 Engine oil disconnection
Engine oil pressure switch condition was OFF, when key switch was
turned on .
17 Alternator charge disconnection Charge signal was ON, when key switch was turned on .
31
The upper bound of the voltage of
the accelerator sensor is
abnormal
Voltage as over 4.8V had been measured over 1.5 second
32
The lower bound of the voltage of
the accelerator sensor is
abnormal
Voltage as under 0.2V had been measured over 1.5 second
33 CAN Communication Error