Takeuchi TB175W, Руководство по ремонту

Страница: 155 / 851

HYDRAULIC UNITS
HYDRAULIC PUMP
IV-21
TB175W
INSPECTION AND ADJUSTMENT
Checking Parts
After checking the disassembled parts for dirt or
discoloration, clean them with diesel fuel. However,
do not let diesel fuel get on rubber parts. Check each
part for the following points and if there is any trouble,
repair or replace the part.
Housing
The gear pump is made so that the crests of the gear
teeth make light contact with the housing walls as a
means of increasing its efficiency. Therefore, contact
marks can be seen near the suction port in any pump
that has been operated.
It is normal if the depth of the contact marks is within
0.1 mm. If the depth exceeds the use limit in the above
figure, replace the pump assembly.
Bushing
The ideal situation is for the sliding surfaces to have
no roughness and for the suction side half to be
lustrous. Also, it is satisfactory if strong contact
marks can be seen on the side surface on the suction
side and minute contact marks can be seen on the
discharge side.
• Contact marks can be seen on the sliding surface of
the entire bearing inner diameter and it is so rough
that it looks like it has been clawed.
• There is a large number of scratches around the
circumference of the side surface and it is so rough
that it looks like it has been clawed.
• There are marks from foreign matter biting into the
sliding surface of the bearing inner diameter and
the side surface.
Dirty hydraulic oil is one likely cause of such wear. In
such a case, replace the hydraulic oil and flush out
affected hydraulic circuit completely.
DISCHARGE SIDE
SUCTION SIDE
CONTACT MARKS
T7D157E T7D158E
A
SUCTION SIDE DISCHARGE SIDE
CONTACT MARKS
DEPTH OF CONTACT MARKS:
A 0.15mm