Takeuchi TB175W, Руководство по ремонту

Страница: 774 / 851

TB175W REV. 1 7
INSTALLATION INSTRUCTIONS
Before mounting the swivel joint on a Grau swivel joint for hydraulic applications, connector 13 must be removed by loosening
bolts 12 (by about 2 turns). The swivel joint mount is then placed with intermediate piece 9 through the central bore of the swivel
joint for hydraulic applications and fastened with the flange bolts.
Finally, connector 13 is slid with seals held in place by bolts 12 over the protruding intermediate piece 9, with the locator pin
sitting in the correct position in the connector.
Bolts 12 are tightened again to secure connector piece 13 and to seal the connectors.
Make sure there is sufficient play between the housing mount and the counter-piece.
There must be no tension when the tubes are connected, preferably with hose connectors. Additional lateral loads on the rotating
connector induced by too short or inflexible hoses must be avoided.
MAINTENANCE
If the installation instructions are observed to the letter, no maintenance will be required.
INSTALLATION DRAWING
532 124 000 2
These installation instructions correspond to the present state of knowledge and are subject to revision. Grau accepts no
responsibility for application beyond those covered n these installation instructions. Special consultation is required in these
cases.
Changes in accordance with technical progress are reserved. Changes, even with our consent, must be authorized by our
modification department.